[Thread Prev][Thread Next][Index]

Re: Decimal digits in contour labels

> **** Control over the spacing of contour labels ****
> The magic argument that gives some control over this is a little
> goodie on the CONSET command -- the "dslab" (delta arc length) which
> controls the nominal spacing of contour labels (see page 12-4 of the
> PLOT+ Users Guide). The example below illustrates.
> ! make the labels closer together    <== THIS IS THE KEY!
> ppl conset .2,,,,,,,1
> contour/i=1:20/j=1:20 (x^2 + y^2) ^ 0.5

Sorry for not responding earlier but I was away last week.  I changed
this DSLAB parameter to 0.5 and decreased a little bit the label height
and finally got plenty of contour labels.

Thanks to everyone that helped.

Michel Beland                 beland@CERCA.UMontreal.CA
professionnel de recherche    tel: (514)369-5223  fax: (514)369-3880
CERCA (CEntre de Recherche en Calcul Applique)
5160, boul. Decarie, bureau 400(423), Montreal (Quebec), Canada, H3X 2H9 

[Thread Prev][Thread Next][Index]

Dept of Commerce / NOAA / OAR / ERL / PMEL / TMAP

Contact Us | Privacy Policy | Disclaimer | Accessibility Statement