[Thread Prev][Thread Next][Index]
Re: [ferret_users] difference in on-screen and saved postscript output
Hi Yogesh,
I can't run your script, because you use your own local data files. I
don't see anything wrong with it, but if you can make us an example with
datasets that are included with Ferret, we could test it. I have a
couple of ideas for you to try:
1) Run ferret with the startup option -batch. You will need to comment
out the metafile and Fprint commands in your script, then
> ferret -batch out.ps
yes? go script.jnl
2) or, test and see if the white line is what is causing the trouble. I
was able to run a similar script, and the white line shows up fine, but
as a test, you should draw it in another color and see if it shows up in
the postscript. For example you might try
plot/color=black/thick/dash/nolab/ov ...
If this is the case, you could hunt for "white line" in the Users List
archives and see if there are any suggestions.
Yogesh Tiwari wrote:
Hello Ferret Users,
I am using Ferret v5.81 on Linux.
I run a script to save a plot in postscript format.
In the script I do
1)fill
2)countour/ov
3)plot/ov
Script works fine and on screen I get all the above three.
BUT, when I exit ferret and check .ps file then I get only above two
(fill, countour/ov), the line plotted with 'plot/ov' command is
missing in .ps output.
Here I have attached my script, kindly help where I am doing mistake.
Many thanks,
Regards,
Yogesh
--
Dr. Yogesh K. Tiwari,
Scientist-B,
Indian Institute of Tropical Meteorology Pune,
New Delhi Branch,
Prof. Ram Nath Vij Marg,
R-block, New Rajinder Nagar,
(Near Durga Mandir)
New Delhi-110060
INDIA
Tel.:- 0091-11-28743976 (O)
0091 - 9910059155 (Cell)
[Thread Prev][Thread Next][Index]
Dept of Commerce /
NOAA /
OAR /
PMEL /
TMAP
Contact Us | Privacy Policy | Disclaimer | Accessibility Statement