[Thread Prev][Thread Next][Index]
Re: [ferret_users] [ferret]-how to define irregular z-axis
Hi Yogesh,
The ZAXREPLACE function does this. You define the Z axis that you want,
in this case Z in pressure units, and a function which converts between
the existing units and the output units. Then call ZAXREPLACE to apply
the conversion and put your data on the desired axis.
Yogesh K. Tiwari wrote:
Hello Ferret Users,
I have a netcdf data and when I use this ferret says as follows :-
yes? use q.nc
*** NOTE: Units on axis "sig_s" are not
recognized: sigma_level
*** NOTE: They will not be convertible:
*** NOTE: bounds "bounds_LAT" do not enclose
point on axis LAT
*** NOTE: Substituting coordinate midpoints
*** NOTE: bounds "bounds_LON" do not enclose
point on axis LON
*** NOTE: Substituting coordinate midpoints
In fact the veritical axis is irragular pressure axis in mb(19 mb
pressure values on the place of 19 sigma level values) :-
999.956798673119
982.300930711410
958.711821388422
923.727954421369
872.668797870758
802.135476614033
710.819107916518
600.936070971621
480.335709752363
363.907443320277
269.693181583253
205.375139312848
159.597308168984
120.320114961464
86.0958233667092
57.7252298204432
35.5095334329671
19.1474920954818
7.76486715808502
My question is how to define the irregular 19 pressure axis values
instead of each 19 sigma level while reading and ploting the data.
Thanks,
Yogesh
[Thread Prev][Thread Next][Index]
Dept of Commerce /
NOAA /
OAR /
PMEL /
TMAP
Contact Us | Privacy Policy | Disclaimer | Accessibility Statement