Dear Sir
I installed las 6.0 in redhat 7.3
under /namba/las
Everything has been done without any problem in configuration "./configure" in las.
Then I edit /etc/httpd/conf/srm.conf adding two lines like below
Alias /las/server /namba/las/server
Alias /las/server /las/server/las-output
Then
./startserver.sh in /namba/las
When I access the LAS from the same computer by URL
202.184.40.34:8080/las/servlets/dataset
LAS user interface come up without any problem.
It proceeds to "Datasets" and next "Variables" without any problem.
But when I go to "Constraints", then push "next: but I could not get any output (can not proceed to "output").
"Constraints" stay bold and I can not go to "Output" or go back to "Datasets".
Even I push the "Output" or "Output Option", output or Output option display do not show up.
Also I can not do Zoom in and Zoom out.
Could you give me any opinion?
Thank you in advance.
Takaya Namba
--- Begin Message ---
- To: las_users@xxxxxxxxxxxxxxxxxxx
- Subject: problem of las 5.0 in redhat 7,0
- From: Namba Takaya <takayanamba@xxxxxxxxxxx>
- Date: Fri, 27 Dec 2002 12:08:29 +0000
- Cc: John.C.Cartwright@xxxxxxxx
- Sender: owner-las_users@xxxxxxxxxxxxxxxxxxx
Dear LAS users
Thank you for your support.
We have our LAS server 5.0 runnig in redhat 7.0
http://202.184.30.8/las/main.pl
It looks working very well at a glance.
but for exmaple when we choose the "tline" of "Sea Surface Temperature Monthly Mean at Surface" in "Coads 1-degree Standard" there and choose slect time range 1960-1970 (full range is 1960 - 1997), then error come up
The region you chose is too small
Please try again after selecting a larger region.
..............................................
This is "tline" graphy so this error shoud not come up. The point must be accepted.
In case of full range from 1960 to 1997, it is working very well outputing time series graph without any problem.
Could you tell me how to solve this problem?
Regards
Takaya Namba
今が旬のクルマを徹底的に分析します MSN 自動車 --- End Message ---