Hi Carlos,
Yes, there's a method for this, using the SAMPLEXY function. You
can define a set of x and y locations, and if it's a diagonal, then
it's even easier, using the script vertical_section.jnl. For an
example of that,
yes? go/help vertical_section
And the documentation of SAMPLEXY has a bit more. I hope this will
get you started.
Ansley
On 12/11/2012 5:24 AM, CARLOS ROMÁN
CASCÓN wrote:
Hi,
I have a domain x,y,z. I usually contour or fill
a profile for the whole z, a fixed i and a range of j: /j=1:60/i=60/
but..
how can I contour for the whole z but from i,j (1,1) to i,j
(60,60), i.e. i don't want a profile with the x axis of the
graphic with latitudes or longitudes, I do want it but for a
diagonal in the domain. Maybe the attached picture (domain.png)
explains it in a better way. I want a figure like "example.png"
but with the x axis with a non-fixed longitude, i.e. the xlat and
xlong must change and plot points
ij=(1,1),(2,2),(3,3),...,(60,60).
Thank you very much in advance and sorry if my explanation is not
very good
Regards
Carlos
|