Re: [ferret_users] [ferret_users 5.70] shade, plot viewport

[Yogesh Tiwari <yogesh.mpi@xxxxxxxxxxxxxx>]

Hello James,

 

You can use define view command. Using this command you can control your figure and plot sizes, for example

 

DEFINE VIEW/XLIM=.22,.42/YLIM=.70,.90/AXES ONE

SET VIEW ONE

shade a

DEFINE VIEW/XLIM=.52,.73/YLIM=.70,.90/AXES TWO

SET VIEW TWO

plot b

.................

Good luck,

Cheers,

Yogesh

On 5/22/06, jimmyc@iastate.edu <jimmyc@iastate.edu> wrote:

Hi All-
I have 6 viewports set up in "4" viewport space (see attached gif image).
The problem is that the 1st plot is a shade with color key while the 2nd
is a plot. I would like to scale the 2nd plot to match the xaxis labels of
the shaded plot.
I tried the "ppl list labels" but nothing happened.
Is there a way to find out what the dimensions or position of the shade
plot are so I can have the plot viewport match?
Thanks


--
James Correia Jr.
Ph.D. Candidate in Agricultural Meteorology
Former President: ISU Graduate Meteorology Club
Dept. of Agronomy, Iowa State University
*********************************************
Email: jimmyc@iastate.edu
Phone: 515-294-9870
Web: http://bruce.agron.iastate.edu/jimmyc/
ISU GMC: http://www.stuorg.iastate.edu/gmc/
*********************************************
"There is a difference between knowing the path and walking the path"
-"Morpheus"

"Wisdom. Strength. Courage. Generosity. Each of us are born with one of
these. We must find the other three inside of us."
from "Into the West"

-- 
Dr. Yogesh K. Tiwari, 
Scientist-B,
Indian Institute of Tropical Meteorology Pune, 
New Delhi Branch,
Prof. Ram Nath Vij Marg,
R-block, New Rajinder Nagar,
(Near Durga Mandir)
New Delhi-110060
INDIA

Tel.:- 0091-11-28743976 (O)
        0091 - 9910059155 (Cell)