Re: [ferret_users] quicker detection of dimensions improperly specified

[Hein Zelle <hein.zelle@xxxxxxxxxxxxx>]

Dear Ferret users, 

> Ryo Furue wrote:
>
> I'm wondering if it's possible to detect an improper dimension
> specification, such as
> 
>   yes? fill  some_3D_variable
> 
> UP FRONT . . .  It sometimes takes quite a bit of time before we
> see the error message

I'll second that request - it happens to me a lot, and I also see our
newer ferret users running into it all the time.  The only thing which
works immediately is control-backslash, but since that kills ferret
it's not a very good solution ...

Kind regards,	   
     Hein

-- 

Dr. Hein Zelle
Senior consultant meteorology & oceanography

Tel:        +31 (0)527-242299
Fax:        +31 (0)527-242016
E-mail:     hein.zelle@xxxxxxxxxxxxx
Website:    www.bmtargoss.com
	    
BMT ARGOSS b.v.

Voorsterweg 28, 8316 PT Marknesse, the Netherlands
Postal address: P.O. Box 61, 8325 ZH Vollenhove, the Netherlands

Registered in The Netherlands, Registered no. 39060160.

Unless otherwise agreed by BMT ARGOSS in writing, all work,
services, goods or products supplied by BMT ARGOSS shall be subject
to and governed by BMT ARGOSS' own terms and conditions which are
available for inspection from BMT ARGOSS on request.

----Confidentiality Notice & Disclaimer---- 

The contents of this e-mail and any attachments are intended for the
use of the mail addressee(s) shown. If you are not that person, you
are not allowed to read it, to take any action based upon it or to
copy it, forward, distribute or disclose the contents of it and you
should please delete it from your system. BMT ARGOSS does not accept
liability for any errors or omissions in the context of this e-mail or
its attachments which arise as a result of internet transmission, nor
accept liability for statements which are those of the author and
clearly not made on behalf of BMT ARGOSS.