Re: [ferret_users] bad graphics

[nuncio@xxxxxxxxx]

HI ,
 I used just the "contour" command

 contour/y=-45/t=1-jan-2012:31-jan-2012 pres

but this improve if I issue

contour/y=-45/t="1-jan-2012 00:00:00":"31-jan-2012 13:00:00" pres

anything less than 31-jan-2012 13:00:00 wont work

If I want to plot for the first 15 days, 1-15 jan 2012, above syntax does'nt work
but, contour/y=-45/t="1-jan-2012 00:00:00":"15-jan-2012 00:00:00" pres works
Is this a problem with NetCDF file ? but why Ferret is confused here I am not getting !

file used is pres.sfc.2012.nc daily ncep surface pressure

Ferret is loaded on openSuSE12.1
 

Best regards
nuncio

Nuncio Murukesh
Scientist.
National Centre for Antarctic and Ocean Research
Headland Sada, Vasco Da Gama
Goa, 403804
India.
Ph: Cell-91 989035742331
    off- 91 832 2525636

----- Original Message -----
From: "Ansley Manke" <ansley.b.manke@xxxxxxxx>
To: nuncio@xxxxxxxxx
Cc: "ferret" <ferret_users@xxxxxxxx>
Sent: Tuesday, April 24, 2012 10:16:25 PM GMT +05:30 Chennai, Kolkata, Mumbai, New Delhi
Subject: Re: [ferret_users] bad graphics

Hi Nuncio,
Is that plot drawn using a single CONTOUR command?  Please write back 
and include more information about the commands that you used.

--Ansley

On 4/23/2012 9:35 PM, nuncio@xxxxxxxxx wrote:
> Hi all,
>         For a hovemoller plot of NCEP surface pressure FERRET gives misplaced ticks and axes. Please see the attached figure
>
> any suggestions?
>
> best regards
> nuncio
> Nuncio Murukesh
> Scientist.
> National Centre for Antarctic and Ocean Research
> Headland Sada, Vasco Da Gama
> Goa, 403804
> India.
> Ph: Cell-91 9890357423
>      off- 91 832 2525636