[Thread Prev][Thread Next][Index]

Re: overlay



Hi Andreas,

Sorry for the delay answering.

The commands you show aren't valid as-is. PLOT/SET_UP must be followed by an
actual plot before an overlay can be done. Specifically, the commands should
be

     plot/line=13/nolab/set_up/i=1:10  1/i
     ppl plot
     plot/line=15/nolab/set_up/ov/i=1:10  2/i
     ppl plot/over

Curious why this **did** work in V4.9 ...

    - steve

=================================

Andreas Schmittner wrote:

> Hi all,
>
> I encountered a little difference between versions
> 4.9 and 5.0. In version 4.9 the following will
> lead to two lines:
>
> plot/line=13/nolab/set_up/i=1:10  1/i
> plot/line=15/nolab/set_up/ov/i=1:10  2/i
> ppl plot
>
> In version 5.0 (beta 1.1) only the second line is drawn.
> Is that a buck of v5 or did I make something wrong?
>
> Thanks,
>
> Andreas
> --
> --------------------------------------------
> Andreas Schmittner
> Climate and Environmental Physics
> Physics Institute        http://www.climate.unibe.ch/~aschmi/
> University of Bern                  schmittner@climate.unibe.ch
> Sidlerstrasse 5                                 phone:  +41 31 631 34 02
> 3012 Bern, Switzerland                      fax:  +41 31 631 44 05
> --------------------------------------------

--
Steve Hankin
NOAA/PMEL, 7600 Sand Point Way NE, Seattle, WA 98115-0070
ph. (206) 526-6080 -- FAX (206) 526-6744




[Thread Prev][Thread Next][Index]

Dept of Commerce / NOAA / OAR / PMEL / TMAP

Contact Us | Privacy Policy | Disclaimer | Accessibility Statement