|
Dear ferret users I have been trying to do some correlation analysis
between two different datasets, both which I have converted to identical time axes. I can get a correlation only
when I request a single point from each dataset. There does not appear to be any information on this
in ferret pages or previous users (excepting 2002 where a similar question was
asked but never answered). I have read the script under “correlation analysis”
but this is of no help. When the script is run, a bad flag occurs and a error
message of ‘not equal sizes on the x axis’ occurs. It should be possible to get a correlation between
two different regions from two different datasets (such as SST and rainfall
over land) , as long as the time axis and intervals are the same
for each dataset. Any ideas? Thanks in advance Andy Cottrill This email (including any attached files) is confidential and is for the intended recipient(s) only. If you received this email by mistake, please, as a courtesy, tell the sender, then delete this email. The views and opinions are the originator's and do not necessarily reflect those of the University of Southern Queensland. Although all reasonable precautions were taken to ensure that this email contained no viruses at the time it was sent we accept no liability for any losses arising from its receipt. The University of Southern Queensland is a registered provider of education with the Australian Government (CRICOS Institution Code No's. QLD 00244B / NSW 02225M) |