cross section

[jimmyc@xxxxxxxxxxx]

Fereteers:

I have pressure as my vertical coordinate. Pressure decreases with 
altitude.
When I plot a cross section the top of my "atmosphere" is on the bottom of 
the plot while the bottom of my "atmosphere" is at the top.
Is there any way to reverse the axis so that:

Plot:
level 1: 100 millibars
.
.
.
level 21: 1000 millibars

instead of:

level 21: 1000 millibars
.
.
.
level 1: 100 millibars

?
Thanks for any help.


--
James Correia Jr.
Ph.D. Candidate in Agricultural Meteorology
President (Dictator) of the ISU Graduate Meteorology Club
Dept. of Agronomy, Iowa State University
*********************************************
Email: jimmyc@iastate.edu
Phone: 515-294-5587
Web: http://www.mesoscale.iastate.edu/jimmyc/
ISU GMC: http://www.stuorg.iastate.edu/gmc/
*********************************************
"There is a difference between knowing the path and walking the path"
-"Morpheus"

"Scientific theories are built to be used, but they must be mistrusted, 
tested and improved."
-Balik and Frank