Dear Jonathan Callahan
Thank you very much for your kind support.
Still the Las 6 does not work.
I am using PC not Macintosh.
>If you are on a PC you should make sure that you are waiting until the >map applet is fully loaded before you try to do anything on the >constraints page.
Yes I was waitiong but the result is the same.
>My first suggestion for fixing the problem would be to try the following > >stopserver.sh >startserver.sh >
I did "./stopserver.sh" and then "./startserver.sh". The result is the same.
>--> see if it works
(what does it mean " -->see if it works")
When I do ./startserver.sh
the message is
Using CATALINA_BASE: /namba/las/las_servlet/jakarta
Using CATALINA_HOME: /namba/las/las_servlet/jakarta
Using CATALINA_TMPDIR: /namba/las/las_servlet/jakarta/temp
Using JAVA_HOME: /usr/java/j2sdk1.4.1_01
>configure
What does it mean "configure".
I already did "./configure" before "./startserver.sh".
>--> see if it works
What does it mean "-->see if it work".
>Sometimes the servlet gets hung and restarting it will solve the
>problem. Other times the database gets corrupted and reconfiguring will >reload the database.I did reconfigureing many times but the results are the same.
Also I can not do "Zoom in" and "Zoom out". Also I can not chane "Don't use map applet" to "use map applet".
Could you give me any opinion on these problems.
Best Regards
Takaya Namba
>Let us know if either of these works or if they don't.
> > >-- Jonathan Callahan > > >Namba Takaya wrote: > > > > Dear Sir > > > > I installed las 6.0 in redhat 7.3 > > > > under /namba/las > > > > Everything has been done without any problem in configuration > > "./configure" in las. > > > > Then I edit /etc/httpd/conf/srm.conf adding two lines like below > > > > Alias /las/server /namba/las/server > > > > Alias /las/server /las/server/las-output > > > > Then > > > > ./startserver.sh in /namba/las > > > > > > > > When I access the LAS from the same computer by URL > > > > 202.184.40.34:8080/las/servlets/dataset > > > > > > > > LAS user interface come up without any problem. > > > > It proceeds to "Datasets" and next "Variables" without any problem. > > > > But when I go to "Constraints", then push "next: but I could not get > > any output (can not proceed to "output"). > > > > "Constraints" stay bold and I can not go to "Output" or go back to > > "Datasets". > > > > Even I push the "Output" or "Output Option", output or Output option > > display do not show up. > > > > Also I can not do Zoom in and Zoom out. > > > > Could you give me any opinion? > > > > Thank you in advance. > > > > Takaya Namba > > > > > > > > > > > > > > > > ---------------------------------------------------------------------- > > $B%-%c%j%"%"%C%W$rL\;X$9$"$J$?$N%J%S%2!