[Thread Prev][Thread Next][Index]
Re: inward tics, and fill
Hi Zuojun,
This solution is a bit "kludgy" -- but you can always overlay a SHADE with
no contents to force a redraw of the axes. Example:
ppl tics .0,.35,.0,.35,1,1
fill/i=1:5/j=1:5/hlimits=1:5/vlimits=1:5 i+j
shade/i=1:5/j=1:5/over/nolab/nokey/lev=(-999) 0*(i+j)
your old pal - steve
==========================
Zuojun Yu wrote:
> Thanks, Mick.
>
> > Your use of the "ppl tics" command is not in accordance with
> > the Plotplus manual. There are additional arguments for positioning
> > the x and y tics
> > ppl tics,smx,lgx,smy,lgy,IX,IY
> > IX and IY are 1,0,-1 for tics inside, straddling, and outside the axis
> > with -1 as default.
> > So try
> > ppl tics .0,.35,.0,.35,1,1
> > and see if some of your problems are solved.
> > The problem in the lower left of the x and y labels may persist. One
> > way out may be to eliminate one or other of them with the "ppl xaxis"
> > or "ppl yaxis" command
> > e.g. ppl xaxis,0.01,100,10 should get rid of the 0deg label.
> >
>
> It works perfectly, even the labels at the lower left corner are fine.
>
> Any suggestions as to how to keep these inward tics from being covered
> by "fill"? The resolution with "shade" just isn't as good as "fill".
>
> Aloha,
> Zuojun
--
| NOAA/PMEL | ph. (206) 526-6080
Steve Hankin | 7600 Sand Point Way NE | FAX (206) 526-6744
| Seattle, WA 98115-0070 | hankin@pmel.noaa.gov
[Thread Prev][Thread Next][Index]
Dept of Commerce /
NOAA /
OAR /
PMEL /
TMAP
Contact Us | Privacy Policy | Disclaimer | Accessibility Statement